H6A4A11128G5AZ/ H6A4A11256G5AZ/ H6A4A11512G5AZ

Commercial SATA 2.5" SSD

Axeme's 2.5" SATA Solid State Disk (SSD) delivers all the advantages of flash disk technology with Serial ATA I/II/III interface, including being fully compliant with standard 2.5-inch form factor, providing low power consumption compared to traditional hard drive and hot-swapping when removing/replacing/upgrading flash disks. The device is designed based on the standard 7-pin interface for data segment and 15-pin for power segment, as well as operating at a maximum operating frequency of 200MHz with 30MHz external crystal. Moreover, it can reach up to 550MB/s read as well as 500MB/s write high performance measured by CrystalDiskMark v5.0).
Features
  • Capacities
    – 128GB, 256GB, 512GB
  • Form Factor
    – 2.5" SSD
  • SATA Interface
    – SATA Gen3
    – SATA Revision 3.2
  • Flash Interface
    – Transfer rate up to 533MT/s
  • Performance1
    – Read: up to 550 MB/s
    – Write: up to 500 MB/s
  • Reliability
    – Mean Time Between Failure (MTBF) 2,000,000 hours
  • Advanced Flash Management
    – Dynamic Wear Leveling
    – Bad Block Management
    – TRIM
    – SMART
    – Over-Provision
    – Firmware Update
    – SmartZIP™
  • Power Consumption2
    – Power supply of 2.5" SSD: 5V±5%
    – Active Mode (Typ.) < 2,120 mW
    – Idle < 365 mW
    – DEVSLP mode: < 5 mW
  • Temperature Range
    – Operation: 0°C ~ 70°C
    – Storage: -40°C ~ 85°C
  • RoHS-Compliant